首先我們先介紹一下軟管泵，軟管泵又稱蠕動泵。為了泵體污染流體或流體污染泵體的危險性，整個泵的裝置中只有軟管與介質接觸。在一般場合下，軟管泵使用的都是天然橡膠的軟管。內層和外層都是完整光滑的天然橡膠，其目的是很強防磨損。適用于腐蝕性不高但磨損性很大的如泥漿以及無機物等等介質。而且一般適用于脂肪、油類或油脂的介質，以及有機化學物質。內層是橡膠，而外層是天然橡膠或者是復合橡膠。

First of all, lets introduce the hose pump, which is also called peristaltic pump. In order to eliminate the danger of the pump body contaminating the fluid or the fluid contaminating the pump body, only the hose in contact with the medium in the entire pump device. In general, hose pumps use natural rubber hoses. The inner and outer layers are completely smooth natural rubber, the purpose of which is to prevent abrasion. It is suitable for mediums that are not corrosive but very abrasive, such as mud and inorganic substances. And generally suitable for fats, oils or oils, and organic chemicals. The inner layer is rubber, while the outer layer is natural rubber or composite rubber.

 

軟管泵壓輥的調整
泵出廠時，壓輥已按正常情況調整到位，如遇物料吸不上，或在泵的額定壓力下，口量達不到要求，請調整壓輥的偏心距，其步驟如下：
（1）先將泵殼兩側相應的圓孔有機玻璃蓋板與泵出口端的長方形有機玻璃蓋板打開，將轉子壓輥旋轉至兩圓孔之間，其螺栓正對圓孔，然后用套筒扳手將兩端螺栓擰松，再用小圓棒或十字螺絲刀，對準標有0，1，2，3的圓孔，撥動壓輥一側內的偏心套轉動，偏心套的數字越大，其壓輥與泵殼間的距離越小，軟管壓的越緊，其調整是以轉子的頂端的刻線為基準，數字越大，壓的越緊，反之亦然。
（2）調整間隙時一定要注意不要壓的過緊，以達到流量為準，壓的越緊，對膠管的壽命影響越大。